Mobile AIS receiver – raspAIS (A21100)

• mobile AIS antenna
• USB (4x) (not for AIS)
• LAN
• HDMI
• AUX output (3.5mm)
• WiFi

• 2-channel VHF receiver for both AIS frequencies
• Connection port for mobile AIS antenna
• Connection ports for USB, LAN, HDMI and 3.5 mm audio output
• WiFi and LAN connectivity
• Pre-installed AIS software “openPlotter”
• Based on Raspberry PI® Model 3B
• Dimensions (L/W/H): 85 x 56 x 45 mm
• Weight: 150g
• An external GPS source is required,
  e.g., a GPS USB stick.

• Mobile AIS receiver raspAIS consisting of:
  • 2-channel AIS receiver module
  • BNC antenna socket
  • Raspberry Pi 3 Model B
  • Micro SD card (16GB) with operating system and navigation software
  • Housing
• Cable: Micro USB to USB
• VHF antenna (162 MHz) with magnetic base
• User Guide

Note: No power pack included! Use a 5V DC power supply with at least 2A output current. Pure operation via the USB socket on the laptop/PC is not possible!

Accesories:

• 5V car power adapter USB (12V to 5V DC) >
• 5V plug-in power supply USB (230V AC to 5V DC) >

RASPBERRY PI

Please keep the device out of reach of children!

When operating a vessel, it is the sole responsibility of the vessel’s captain to operate the vessel safely and maintain full control of all sailing conditions throughout the entire voyage. Incorrect behavior by the captain of a vessel equipped with raspAIS, where the driver fails to pay full attention to the operation of the vessel and the surrounding conditions, may result in an accident or collision resulting in property damage or personal injury.
It is the sole responsibility of the user to use raspAIS prudently. The raspAIS does not relieve you of your duty of care!

To avoid malfunction or damage to this product, please note the following:

• Do not expose the product to water or moisture during operation and do not place it on a conductive surface.
• Do not expose it to heat; Raspberry Pi 5 is designed for reliable operation at normal ambient temperatures.
• Store it in a cool, dry place.
• Handle carefully to avoid mechanical or electrical damage to the circuit board and connectors.
• Avoid handling the circuit board while it is powered on, or handle it only by its edges to minimize the risk of damage from electrostatic discharge.

WARNINGS

• This product should be operated in a well-ventilated environment. If used in an enclosure, the enclosure should not be covered.
• During use, this product should be securely secured or placed on a stable, flat, non-conductive surface and should not come into contact with conductive objects.
• Connecting incompatible devices to the Raspberry Pi 5 may compromise compliance, cause damage to the device, and void the warranty.
• All peripheral devices used with this product should comply with the relevant standards of the country of use and be appropriately labeled to ensure that safety and performance requirements are met.